IMU with IMS 3 subsystem Separation with double magazine

IMU with IMS 3 subsystem Separation with double magazine

 

 

A workpiece carrier is located on the Mechatronic Unit. The carrier is positioned under one of the two shafts for the gravity-feed magazine. The sorting station has two magazines that accommodate six bottom pieces. One piece is selected and placed in the carrier. The carrier and its load are then conveyed to the end of the belt to be passed on to the next sub-system.

Weboffer

 0 Article
Equipment set / product

Equipment set comprising the following:
1
Industrial Mechatronic Unit
 Industrial Mechatronic Unit LM9536
1
Mounting double station
 Mounting double station LM9646
1
Workpiece transport pallet
 Workpiece transport pallet LM9520
2
Workpiece, bottom section, white
 Workpiece, bottom section, white LM9524
2
Workpiece, bottom section, black
 Workpiece, bottom section, black LM9525
Accessories:
1
Interface cable 25-pin, Sub-D socket / plug 1m
 Interface cable 25-pin, Sub-D socket / plug 1m LM9066
Media:
1
Interactive Lab Assistant:
Interactive Lab Assistant: SO2805-5J
1
Interactive Lab Assistant:
Interactive Lab Assistant: SO2805-5X
1
QuickChart IMU Industrial Mechatronic Unit
 QuickChart IMU Industrial Mechatronic Unit SO6200-2U
1
SO6200-2Q
Additionally recommended:
1
Compressor, low-noise
Compressor, low-noise SE2902-9L
1
Tubing and accessory set for mechatronics systems
 Tubing and accessory set for mechatronics systems LM9571
1
Set of Allen keys
 Set of Allen keys LM9716

In areas where there are high levels of humidity the membrane dryer

with water trap should be used to avoid...   more

1
IDG3 membrane dryer with rapid coupling and filter AF20 with water trap
IDG3 membrane dryer with rapid coupling and filter AF20 with water trap LM9671