Item No.: CO3216-1Z

OBD II simulator with CAN interface and scan tool

This OBD II simulator can be used for simulating exhaust gas data. Potentiometers allow for sensor data, such as speed or rev-count sensors, to be altered “during travel”, so to speak. In addition, buttons are provided to simulate faults in the vehicle, which leaves a fault entry in the electronic control unit and causes the malfunction indicator light to display. The relevant button can then be used again to cancel these functions in the tester. In this way it is possible to practically analyse test conditions in a much easier fashion than on a full-scale vehicle, as the latter would mean physically manipulating the electrical system of the vehicle itself.

Technical data

  • Original OBDII/EOBD interface
  • CAN interface
  • Fault simulation switches
  • Current vehicle data can be modified and read, including air flow, engine temperature, speed and rev count
  • Inputs/outputs: 4mm sockets
  • 2 Safety connection plugs, red, 19/4mm
  • 1 Safety connection plugs, black, 19/4mm
  • Dimensions: 297 x 228 x 70mm
  • Weight: 1.2kg

OBD Scantool accessories:

  • All protocols:
    • PWM
    • VPWM
    • ISO9141-2
    • KWP2000 5baud init
    • KWP2000 fast init
    • CAN
  • Integrated software and fault database featuring well over 500 fault codes with explanatory text.
  • Multilanguage
  • Function for clearing MIL fault display on the dashboard display
  • Fault codes can be read and deleted
  • Selected freeze-frame environments can be invoked.
  • Simple operation via intelligent menus using just two buttons.