Item No.: CO3221-6A

CAN fault simulator

The CAN fault simulator can be integrated into any CAN-bus data line. The actual fault circuit is located inside a lockable lid where eight switches are used to enable the standard ISO faults.

 

The following faults can be activated:

  • Break CAN-Low

  • Break CAN-High

  • Fault to battery positive CAN-Low

  • Fault to earth CAN-High

  • Fault to earth Can-Low

  • Fault to battery positive CAN-High

  • Fault CAN-High to CAN-Low

  • 500 Ohm resistance in CAN-High line

 

Panel description

  • Compatible to Low-Speed and High-Speed CAN-bus (ISO 11898-2 and ISO 11898-3)

  • Operating voltage 12V/13.8V

  • Inputs: 2 mm measurement sockets and 4-mm safety sockets

  • Outputs: 2 mm measurement sockets and 4-mm safety sockets

  • Vehicle-specific terminal designation

  • Continuous power supply via terminal 30 and 15 in the upper region

  • Continuous ground via terminal 31 in the lower region

  • Coloured screen printing

  • Dimension: 297 x 114 x 60mm

  • Weight 1.0 kg