Training content:

• Creation of various network systems in a customer system (TT, TN, TN-C, TN-S, or TN-C-S system)
• Realisation of an independent IT system behind an isolation transformer (with additional module)
• Selection and operating principles of various protective components in different networks
• Familiarisation with various protective systems and how they should be tested using appropriate instruments
• Implementation of initial and periodic inspection and testing in accordance with DIN VDE
• Hazards of electric current
• Advising and instructing persons about the hazards associated with electrical installations
• Assessment of measurements and targeted fault finding
• Compilation of documentation and test reports
• Continuity of equipotential bonding conductors
• Insulation resistance measurement
• Testing of RCDs
• Measurement of loop impedance
• Measurement of local insulation impedance
• Development of legal framework and step sequences for inspection and testing in accordance with EN 50678 (VDE0701 - 12/2020)
• Development of legal framework and step sequences for inspection and testing in accordance with EN 50699 (VDE0702 - 09/2021)
• Transmission of knowledge about protection classes I, II, III
• Familiarisation with equipment symbols and documentation
• Selection and use of measurement and testing instruments in accordance with DIN VDE and DGUV V3
• Planning, implementation and documentation of periodic inspection and testing in accordance with DIN VDE and DGUV V3
• Troubleshooting of systems and equipment and analysis of measurement values
• Assessment of inspection and testing steps and comparison of measurement and limit values