Test device for standards-compliant testing of 1 and 3-phase charging cables mode 2 and 3

The E-Mobility testing device is a portable case for standards-compliant testing of 1 and 3-phase charging cables mode 2 and 3 by simulation of fault cases according to DIN VDE 0701-0702 and manufacturer's data.

• Testing of 1 and 3-phase e-charging cables mode 2 and 3
• Measurement of current in protective earth conductor 
• Measurement of protective earth resistance and insulation resistance according to DIN EN 
• Trip testing with nominal residual current and measurement of the tripping time 
• Analysis and documentation of the individual testing steps 
• Testing of connection cables with country-specific charging plug (plug type 1, etc.)
• Function testing and trip testing by simulating the following fault cases: interruption, interchange of PE and phase lines
• Simulation of vehicle condition according to EN 61851-1
• Testing of resistance designation/labelling for vehicle coupling and plug according to EN 61851-1
• Operating voltage 230V, 50Hz
• Measurement jacks: 4-mm safety sockets
• Inputs/outputs: Standard sockets / plug(s) for charging cable(s)
• Dimensions: 401 x 307 x 173 mm
• Weight: 6.5 kg