Shelf board for SybaPro tiltable and height-adjustable system table, 1200 x 85 x 400 mm

Shelf board for SybaPro system tables with power supply ducting through the rear legs

• Adjustable over a continuous range or to 4 pre-set levels (locked via quick-release clamps), shelf can tilt by up to about 15°
• Highly compressed, multi-layered fine chipboard conforming to DIN EN 14322, 30mm thick with 40mm steel frame
• Colour RAL7035 with 0.8mm, slightly textured laminate coating (Resopal HPL) conforming to DIN 16926 on both sides
• Inset in solid, impact-resistant edging made of 3mm thick coloured plastic, colour grey, RAL7047
• Coating resistant to many chemicals and reagents, such as dilute acids and bases. Also resistant to heat, e.g. liquid solder and point heating caused by soldering irons and similar.
• A steel lip at the front prevents equipment sliding off the table.
• Full-width C-shaped profile at the rear beneath the shelving to act as cable ducting
• Supplied with fastening materials

Dimensions:

• Dimensions (including frame): 1200x85x400mm (w x h x d)