Item No.: CO3223-8B

Light sensor

The light sensor realizes a partially automated driving light control system that is standard equipment in most new vehicles. The incident light is measured by an optoelectronic element or light sensor and evaluated by control electronics. Depending on the result of the evaluation, the low beam is switched on or off. This function is now fully implemented by the handy module "light sensor" and can be retrofitted into your existing lighting wall on CAN basis in a few seconds. Thus, the partially automated driving light control is also available to you in training and offers you further measurement possibilities, so that the system can be understood holistically.

Extended functions through the light sensor:

  • Partially automated driving light control
  • Switching the automatic light system on and off
  • Timing hysteresis when switching on and off
  • Analysis of CAN communication

Elements of the module:

  • Light sensor
  • Control unit
  • Control lamp
  • Switching element for switching the light assistant on and off
  • 4mm safety sockets for the power supply
  • 4mm safety sockets for the CAN bus connection
  • 2mm safety sockets for the CAN bus connection
  • Operating voltage: 12V DC
  • Input and output signals: CAN low speed 125 kBit/s


Learning contents (course duration approx. 4h):

  • Basics light sensor
  • Extension of a CAB bus system
  • The EVA principle
  • Flowchart of a light assistant
  • Design of the electrical circuit
  • Commissioning after the test setup
  • Data communication of the control units
  • Programming of brightness sensitivity in the control unit
  • Control of control units
  • Diagnosis and troubleshooting with customer order
  • Entering workshop order
  • Selection of repair measure according to manufacturer's specification
  • Reprogramming of the control unit
  • Classifying faults in the motor vehicle system
  • Repair method and customer discussion
  • Metrological examination

Scope of delivery:

  • ½ A4 plate with photorealistic illustration for circuit, vehicle and control unit, in desk housing.
  • Module with light sensor, control unit, switching element
  • Dimensions: 297 x 114 x 120 mm / 11,7 x 4,5 x 4,7 inch
  • Weight: 0.6 kg / 1,32 lbs

Please note that the associated e-learning course SO2803-1A must be available in at least version 4.0.0.0 in order to use the module.