MobileTrain "Testing of protective systems in buildings according to VDE / EN"

Compact building power feed with main earthing bar and a load system with fault simulator, preferably deployable for all training programmes and project work relative to "Inspection and testing of a permanent installation according to VDE 0100 part 600." The board contains all the necessary components to implement the testing and potential fault conditions listed.
The fault simulation options and the compact design make this device predestined as a system for vocational training exercises.

• Simulation of a building power feed with main fuse
• Simulation of exterior and interior lightning protection
• Simulation of the meter (counter) with input fuses
• Main earthing bar with all important equipotential bonding conductors and earthing strips
• Realisation of various mains systems with bridging plugs (jumpers)
• Earth loop measurement 

Testing options:

• Configuration of various mains systems (TT, TN, TN-C, TN-S, TN-C-S)
  Analysis of electrical protection systems in the TT and TN system
  Measurements in the single-phase network
  Measurement of the tripping characteristic of a type A and type B RCD
  Measurements in the three-phase network
  Measurement of insulating and loop resistances
  Investigation of common faults
  Initial start-up and periodic inspection and testing of an electrical system
  Documentation and measurement protocol
• Assemblies:
  1 MCB-RCD combination, 10 mA, two-pole type A
  1 RCD 30 mA, four-pole type B
  1 MCB miniature circuit breaker, single-phase
  1 MCB miniature circuit breaker, three-phase
  1 lighting circuit with OFF switch
  2 earth-contact sockets
  1 CEE socket
• 1 fault simulator with 16 fault options, lockable
• Rated voltage: 3 x 230 V/400 V
• Frequency: 50/60 Hz
• Inputs/outputs: 4mm safety jacks
• Dimensions: 600 x 300 x 500 mm
• Weight: 9.2 kg