Item No.: ST8034-2C

Shelf board for SybaPro system table, 1600 mm, tiltable and height adjustable

Shelf board for SybaPro system tables with power supply ducting through the rear legs

  • Adjustable over a continuous range or to 4 pre-set levels (locked via quick-release clamps), shelf can tilt by up to about 15°
  • Highly compressed, multi-layered fine chipboard conforming to DIN EN 14322, 30 mm thick with 40 mm steel frame
  • Colour RAL 7035 with 0.8-mm, slightly textured laminate coating (Resopal HPL) conforming to DIN 16926 on both sides
  • Inset in solid, impact-resistant edging made of 3-mm thick coloured plastic, colour grey, RAL 7047
  • Coating resistant to many chemicals and reagents, such as dilute acids and bases. Also resistant to heat, e.g. liquid solder and point heating caused by soldering irons and similar.
  • A steel lip at the front prevents equipment sliding off the table.
  • Full-width C-shaped profile at the rear beneath the shelving to act as cable ducting
  • Supplied with fastening materials
  • Dimensions (including frame): Dimensions:1600x400x85 mm (WxDxH)